first there was an offline assessment and then shortlisted students were invited to give the interview. Interview lasted for around 40-50 minutes depending on the performance. It was based on analog basics and transient response
Interview questions [1]
Question 1
it was based on analog basics and transient response
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
Keep your basics clear and intuition well prepared. Knowledge in RC and small signal is must. Himangshu Agarwal and Chembiyan T must and basics of opamp etc. Input and output impedance calculations etc.
I interviewed at Texas Instruments (Bangalore Rural)
Interview
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience
